|
Post by kidcrewbob on May 16, 2019 12:36:17 GMT
Urgently need a bespoke tool knocking up to sort some spring loaded driveshafts out - all it would be is a 100mm length of mild steel - 2 x M8 holes and 1 M10 ....and a couple of threaded studs / bolts etc - sure it would take only 30 mins to knock-up with the right tools (bench drill etc) - feel daft ringing the big boys for such a tiny job
TIA
|
|
|
Post by franklin66 on May 16, 2019 12:43:05 GMT
There is a small back street place in Meir St Tunstall.
|
|
|
Post by kidcrewbob on May 16, 2019 14:24:06 GMT
There is a small back street place in Meir St Tunstall. cheers - I'll look them up
|
|
|
Post by cactus72 on May 16, 2019 15:08:24 GMT
Do you have the metal and sizes required?? If not V J Goodalls Longton Rakeway engineering Cheadle Olympus longport Beagle Engineering longton
|
|
|
Post by franklin66 on May 16, 2019 15:37:44 GMT
There is a small back street place in Meir St Tunstall. cheers - I'll look them up Central Hydraulics I think.
|
|
|
Post by Deleted on May 16, 2019 17:07:02 GMT
Are Yates engineering still going? Used to be behind the crown longton
Used to go to school (knock around) with Phil through primary and secondary
|
|
|
Post by kidcrewbob on May 16, 2019 17:43:45 GMT
Do you have the metal and sizes required?? If not V J Goodalls Longton Rakeway engineering Cheadle Olympus longport Beagle Engineering longton No metal but just need 100mm of 25mm flat plate - will try them tomorrow cheers mate
|
|
|
Post by kidcrewbob on May 16, 2019 17:45:01 GMT
cheers - I'll look them up Central Hydraulics I think. Correct but they seem to make some massive stuff - I've dropped them an enquiry anyhow...
|
|
|
Post by cactus72 on May 16, 2019 18:20:02 GMT
I work for a large engineering place, dont carry that sort of stock, if you had the metal could have done the job for you
|
|